Pug's Heating and A/C Plan
This plan provides the best service and parts coverage. It is designed for hot air, steam, or hot water oil-fired systems.

• One cleaning, tune up, and adjustment to the oil burner, furnace or boiler, flue pipe, base of chimney (where accessible), and lubrication of motor and bearings.
• One combustion efficiency test with modern, and accurate instruments to determine fuel efficiency. Equipment is adjusted to maximum efficiency.
• Free labor, service and parts on items listed below, except the "limited items" listed, (these parts will be charged labor and part cost with an allowance of $100.00 towards the replacement part cost).

  PARTS COVERED:
  Air Tube
  Aquastat (plain)
  Burner Motor (up to 1/6 hp)
  Burner Coupling
  Burner Fan
  Burner Nozzle
  Burner Nozzle Adapter
  Burner Nozzle Oil Line
  Burner Retention Head
  Blower Motor (up to 1/2 hp)
  Blower Bearings
  Blower Shaft
  Blower Wheel
  Blower Belt
  Cad Cell Relay
  Cad Cell Eye
  Circulator Coupling
  Delay Oil Valve
  Emergency Toggle Switch
  Fan Limit Control
  Fan Control
  High Limit Control
  High Tension Leads
  Ignition Assembly
  Ignition Cable
  Low Limit Control
  Oil Pump
  Oil Filter
  Oil Filter Cartridge
  Oil Safety Valve
  Oil Pump Strainer
  Pulleys
  Porcelains
  Protectorelay
  Steam Pressuretrol
  Stack Relay
  Steam Air Vents
  Switching Relay
  Turbulator
  Thermostat (plain)
  Transformer
  
  LIMITED ITEMS:
  Automatic Water Feeder
  Clock and Programmable Thermostat
  Circulator Bearing Assembly
  Circulator Motor
  Combustion Chamber (up to 3 gph)
  Expansion Tank
  Flow Valve
  Low Water Cut Off Control
  Mixing Valves
  Multiacting Aquastats
  Oil Tank Above Ground (275 gallon)
  Pressure Relief Valve
  Zone Valve & Power Head

This plan also combines Pug's 15-point precision tune-up with extensive parts coverage for your Air Conditioner or Heat Pump.

PUG'S 15 POINT PRECISION TUNE-UP:

• Check Starting Capabilities
• Check Safety Controls
• Check and Replace Air Filter (supplied by owner)
• Check Thermostat Calibration
• Check all Electrical Connections
• Check Voltage and Amperage on Motors
• Lubricate All Moving Parts Where Necessary
• Clean and Check Condenser
• Clean and Check Evaporator Coil
• Check Operating Pressures
• Check Refrigerant for Proper Amount
• Check and Adjust Blower Components
• Check for Correct Air Flow
• Clean Condensate Drain where accessible
• Check for Proper Temperature Difference

Free labor, service and parts on items listed below.

PARTS COVERED:
Accumulators
Blower Motor
Blower Pulley
Blower Wheel
Compressors (under warranty)
Condensate Pump
Condenser Coils (under warranty)
Condenser Fan
Condenser Motor
Contractors
Crankcase Heater
Defrost Relay
Defrost Switch
Defrost Timer
Expansion Valves
High Pressure Control
Holding Relay
Low Pressure Control
Motor Protectors
Motor Starters
Outdoor Fan Blades
Outdoor Fan Motor
Outdoor Unit Relays
Potential Relay
Rain Shield
Reversing Valve
Reversing Valve Solenoid
Running Capacitors
Starting Capacitors
Starting Relay
Thermostat (standard)
Thermostat Subbase (standard)
Time-Delay Control
Timer Relays
Transformers
Wiring in the Condensing Unit

 

Back to Service Policies page.

 

 

HOME PAGE  |  ABOUT PUG'S  |  OUR SERVICES  |  SERVICE POLICIES
PLACE AN ORDER  |  ONLINE BILL PAYMENT  |  CONTACT US